Materials to make slip:
- Bone Dry pieces of clay (make sure it is completely dry and smashed up)
- Water container
- Water
- Vinegar
- Food Processor or Blender
- Squeeze bottler
- Spoon
Step 1: Gather pieces of bone dry clay and smash it into smaller pieces. I used to keep a 5 gallon paint bucket in the front of the classroom for dried out pieces of clay, but then the students started putting pieces of clay that were not bone dry (just dry enough that they didn't want to use it). SO I now keep that bucket hidden from the students and do my own collecting.
![]() |
Bone Dry Clay before it has been smashed |
Step 2: Once you have a pieces of bone dry clay smashed up, put them in some type of container. Fill the container up with water so that it covers the clay completely. Let sit over night
Step 3: Dump out or scoop off the top layer of excess water.
![]() |
This is how the clay should look, completely soaked and settled to the bottom. The excess water will be on top. |
Step 4: Begin scooping the clay into the food processor or blender. I used to use a blender, but it died and the food process works much better at chopping up the clay to a nice consistency. I mix 75% water and 25% watered down clay mixture. At this point I also add a couple cap fulls of vinegar. I don't have a specific amount of vinegar that I use, a little goes a long way. The vinegar acts as a bonding agent/glue for the slip. You do not have to add the vinegar, but I find that it holds the slip together better.
Step 5: Run the blender or food processor until the slip is the consistency of runny yogurt. You may need to add more water along the way.
Storage of the Slip: The slip with vinegar is only good for a couple weeks. After that it can start to grow mold and smell (more than it does already). I don't make a lot at a time for this reason. Take out containers are great to store the slip (i.e. clear wonton soup containers).
Additional Tip: I used to pour out the slip for each table in my classroom to share and cover the containers at the end of the night with saran wrap. The issue I faced with this is the slip drying out after a few days. My new trick is one that I found on Pinterest where you put the slip into squeeze bottle containers- this works great!!!! (I had some left over from tie dying) The squeeze bottles are less messy and all the students have to do is squeeze the slip out to the area that they need to attach. Just make sure if you use squeeze bottles that the opening is cut enough so that the slip can come out easy and make sure that the slip is a little more watered down than yogurt. One other (funny) issue is that if there are air bubble built up in the clay or if there is a chunk of clay that tries to come out, when the student squeezes the bottle the slip kind of flies out and my kids say that it "poops" out- high schoolers for ya!
Hope these tips were helpful!
How do you make your slip?
Do you even use slip or just vinegar? I love to learn about new ideas in your room!
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.